How to use the bending machine

Views: 106 Author: Site Editor Publish Time: Origin: Site

  According to the ordinary hydraulic bending machine processing Q235 sheet to make a brief introduction:

1634865015197260.jpg

  1. First, turn on the power, turn on the key switch on the control panel, and then press the oil pump to start, so you can hear the sound of the oil pump rotating. (The machine does not operate at this time)

  2. Stroke adjustment, the use of the bending machine must pay attention to adjusting the stroke, and be sure to test run before bending. When the upper die of the bending machine descends to the bottom, there must be a gap of plate thickness. Otherwise it will cause damage to the mold and the machine. The stroke adjustment also has electric quick adjustment and manual fine adjustment.

  3. For the selection of bending notches, generally a notch with a width of 8 times the thickness of the plate should be selected . If you bend a 4mm sheet, you need to choose a notch of about 32mm .

  4. Backgauge adjustment generally has electric quick adjustment and manual fine adjustment.

  5. Step on the foot switch to start bending, the foot pedal of the press brake can be released at any time, release the foot and the press brake will stop, and then step on to continue downward.

1634866549719604.jpg