What problems should be paid attention to when operating the automatic pipe bender

Views: 106 Author: Site Editor Publish Time: Origin: Site

The automatic pipe bender can automatically clamp,feed,size setting, stop at a fixed number, and work measurement automatically.The main circuit of the machine adopts PLC programmable logic controller to work. The counter can set the number of cutting times, and it will stop automatically after cutting.There is no need for manual operation at all, higher mechatronics, and even one person can operate multiple machines, reducing the number of employees.When operating the automatic CNC pipe cutting machine, pay attention to the following points:

1. Adjust the cutter and clamp the work object before cutting. The length of the clamping part shall not be less than 50 mm. The parking baffle should be fixed, and work can only be carried out after the sequence of clamping, unclamping, forward and backward test runs.

6066d59f5faf2.jpg

 

2. The spindle speed change must be carried out after stopping. The gears must be fully meshed when shifting. When the machine tool is found to be abnormal, stop and check immediately.

 

3. The machine must be stopped when changing tools, measuring workpieces, smoothing, and finishing pipe heads.

 

4. When the machine tool is rolling, no part of the human body shall touch the transmission parts. When operating, tie the cuffs, and it is strictly forbidden to work with gloves. The human head should deviate from the cutting direction.

 

5. When cutting the tube head, avoid the tube head flying out and hurting people.

 

6. When using the grinding wheel pipe cutting machine, check whether the grinding wheel is damaged, cracked, damp, and the power cord is secure.

 

7. When the long material pipe is put into the material rack and the bundled lead wire is loosened, methods should be taken to avoid the pipe rolling, impact, and crushing people. .

 

8. The dust removal device of the pipe cutting machine should be intact before cutting.

 

9. No one should stand in the direction of the workpiece in and out of the material.

607e8a345bcf9.JPG